Gas Assist Injection Molding, Custom Injection Molding

Gas Assist - "Better Products for Less Cost"

Home · Gas Assist

Gas assist injection molding has been around for approximately 20 years. In introducing gas pressure during the injection phase of the molding cycle less clamping force is required. Therefore, larger parts can be produced on smaller tonnage machines.

The process offers the injection molder solutions to many of the inherent problems associated with injection molding thick walled parts. Machine cycle times can be shorter; less resin is used and smaller tonnage machines all add up to less cost.

Some of the highlights of gas assist are:

Less polymer is needed
Reduced molding cycles
Lower clamping forces
Reduced part weight
Less molded-in stress
Sink mark reduction
Less time to cure
Less warpage and distortion

Applications - most solid parts such as:

Furniture (chair legs, table bases)
Pallets & crates
Tool handles

Alladin Plastics has the capacity of "Gas Assist" molding on machine sizes ranging from 850 tons to 1500 tons.

For further information contact:

Bob Hickman
Phone: (800) 960-2351, ext. 302
E-Mail: .

Gas Assist - "Better Products for Less Cost"

Since 1946Over 60 Years ofAmerican Pride,Quality and Innovation

Since 1946
Over 60 Years of
American Pride,
Quality and Innovation